Skip to content
Engineering Bible

Results appear as you type. Use the arrow keys to move through them and Enter to open one.

Popular

↑ ↓ moveEnter openEsc close

Moment of inertia formulas for common shapes

The second moment of area I measures how a cross-section resists bending; the section modulus S = I / c gives the bending stress, σ = M / S. The formulas below are for bending about the horizontal axis through the centroid. A 100 × 200 mm rectangle has I = 6 667 cm⁴ and S = 667 cm³.

Free to reuse under CC BY 4.0 with a link to this page. Each table downloads as a CSV file.

To compute any value directly: Moment of inertia calculator (section properties)

Section properties about the horizontal centroidal axis

ShapeArea AIxSxrx
Rectangle, width b, height hb hb h³ / 12b h² / 6h / √12
Hollow rectangle, outside b × h, wall tb h − (b − 2t)(h − 2t)[b h³ − (b − 2t)(h − 2t)³] / 122 I / h√(I / A)
Solid circle, diameter dπ d² / 4π d⁴ / 64π d³ / 32d / 4
Tube, outside D, inside dπ (D² − d²) / 4π (D⁴ − d⁴) / 64π (D⁴ − d⁴) / (32 D)√(D² + d²) / 4
Triangle, base b, height h (axis through the centroid)b h / 2b h³ / 36b h² / 24 (apex), b h² / 12 (base)h / √18
I-section, flange b × t_f, depth h, web t_w (no fillets)2 b t_f + (h − 2 t_f) t_w[b h³ − (b − t_w)(h − 2 t_f)³] / 122 I / h√(I / A)

Download this table as CSV

How the table was made

Every formula is checked against the moment of inertia calculator each time the site is built: the build stops if a formula and the calculator disagree.

For a built-up or unsymmetrical section, find the centroid first, then add each part’s own I plus its area times the square of its distance to the centroid (the parallel-axis theorem). Rolled steel sections have root fillets, so their table values differ by a few percent from these sharp-cornered formulas.

FAQ

What is the moment of inertia of a rectangle?
b h³ / 12 about the horizontal axis through its centre, with h the depth in the direction of bending.

What is the difference between I and S?
I governs deflection; S = I / c, with c the distance to the extreme fibre, governs the bending stress.

Sources

  • Young and Budynas, Roark’s Formulas for Stress and Strain, 8th edition, Table A.1.
  • Gere and Goodno, Mechanics of Materials, Appendix E.

Results are estimates. They do not replace the governing code, class or flag requirements, or a check by a competent person. Report a problem