Manufacturing and machining calculators
Machining, sheet metal, welding, presses and moulding, and shop-floor metrics: each calculator gives the formula it uses, the handbook or standard behind it and the limits of the estimate.
12 calculators · Formula sheet · Glossary · Practice problems- Belt conveyor speed and capacity calculatorBelt speed from pulley diameter and rpm, and the capacity in t/h of a flat or troughed belt from width, angles and bulk density (CEMA method).
- Bend allowance calculator (sheet metal flat length)Sheet metal bend allowance, bend deduction, outside setback and flat length for one or many bends, from thickness, radius, angle and K-factor.
- Chip load calculator with chip thinningChip load per tooth from feed rate, rpm and flutes, or the feed rate for a target chip load, with the radial chip thinning factor for light cuts.
- Drill point length calculatorLength of a drill point from diameter and point angle (118°, 135°, 140°), and the depth to drill for a full-diameter blind hole or a through hole.
- Injection molding clamp tonnage calculatorClamp force for an injection mould from projected area, cavities, cold runner and clamp factor or cavity pressure, with the machine size for a margin.
- Machining time calculator (turning, facing, drilling, milling)Cutting time per pass and per part for turning, facing, drilling and milling from length, feed and rpm, and total job time with set-up and handling.
- OEE and takt time calculatorOEE from availability, performance and quality using shift times and part counts, plus takt time from demand and a cycle-time check against it.
- Press tonnage calculator (punching and press brake)Punching and blanking force from perimeter, thickness and shear strength, with stripping force and press margin, and press brake air-bending tonnage.
- Speeds and feeds calculator (milling, turning, drilling)Spindle rpm, feed rate and metal removal rate for milling, turning and drilling, with starting cutting speeds for common materials in HSS and carbide.
- Surface finish converter (Ra, RMS, Rz, N grades)Convert surface roughness between Ra in µm and µin, RMS, Rz and ISO N grades, and the theoretical turning finish from feed and nose radius.
- Tap drill size calculator (metric and UNC/UNF)Tap drill for metric coarse and fine and UNC/UNF threads at any percentage of thread, with the nearest standard drill and the basic pitch and minor diameters.
- Weld metal and filler consumption calculatorWeld metal mass of fillet, single-V and double-V welds, filler needed for SMAW, GMAW, FCAW or SAW, electrodes or wire length and arc time.