Skip to content
Engineering Bible

Results appear as you type. Use the arrow keys to move through them and Enter to open one.

Popular

↑ ↓ moveEnter openEsc close

Surface roughness chart (Ra and N grades)

Surface roughness is usually specified as Ra, the arithmetic mean deviation of the profile. ISO 1302 groups Ra values into roughness grades N1 (0.025 µm, lapped) to N12 (50 µm, rough cast). Drawings in the US give Ra in microinches: 63 µin is 1.6 µm, grade N7, a good machined finish. This chart converts between the three.

Free to reuse under CC BY 4.0 with a link to this page. Each table downloads as a CSV file.

To compute any value directly: Surface finish converter (Ra, RMS, Rz, N grades)

Roughness grades, ISO 1302

GradeRa (µm)Ra (µin)RMS ≈ (µm)Rz ≈ (µm)
N10.02510.02780.100
N20.0520.05550.200
N30.140.1110.400
N40.280.2220.800
N50.4160.4441.60
N60.8320.8883.20
N71.6631.786.40
N83.21253.5512.8
N96.32506.9925.2
N1012.550013.950.0
N1125100027.8100
N1250200055.5200

Download this table as CSV

How the table was made

Grades and Ra values from ISO 1302 and Machinery’s Handbook (Surface Texture, Table 4). RMS (Rq) is about 1.11 Ra for a sine-like profile, and Rz is roughly 4 Ra for turned surfaces; both ratios depend on the profile, so measure them where they matter.

FAQ

What is 32 Ra in micrometres?
32 µin is 0.8 µm, grade N6, a fine machined or ground finish.

Is Ra the same as RMS?
No. RMS (Rq) squares the deviations before averaging, so it is about 11 % higher than Ra on a regular profile.

Sources

  • ISO 1302:2002, Indication of surface texture in technical product documentation.
  • Machinery’s Handbook, 31st edition, Surface Texture, Table 4.

Results are estimates. They do not replace the governing code, class or flag requirements, or a check by a competent person. Report a problem