Specific heat near room temperature unless stated
| Material | c (J/kg·K) | c (kJ/kg·K) | c (Btu/lb·°F) | Heat for 1 kg, +10 K (kJ) |
|---|---|---|---|---|
| Water (liquid, 25 °C) | 4 181 | 4.181 | 0.999 | 41.81 |
| Ice (−10 °C) | 2 030 | 2.030 | 0.485 | 20.30 |
| Air (constant pressure, 300 K) | 1 007 | 1.007 | 0.241 | 10.07 |
| Steam (100 °C, constant pressure) | 2 080 | 2.080 | 0.497 | 20.80 |
| Engine oil (300 K) | 1 909 | 1.909 | 0.456 | 19.09 |
| Ethanol (25 °C) | 2 440 | 2.440 | 0.583 | 24.40 |
| Aluminium | 897 | 0.897 | 0.214 | 8.97 |
| Copper | 385 | 0.385 | 0.092 | 3.85 |
| Iron | 449 | 0.449 | 0.107 | 4.49 |
| Carbon steel (AISI 1010) | 434 | 0.434 | 0.104 | 4.34 |
| Stainless steel 304 | 477 | 0.477 | 0.114 | 4.77 |
| Lead | 129 | 0.129 | 0.031 | 1.29 |
| Concrete (stone mix) | 880 | 0.880 | 0.210 | 8.80 |
| Glass (plate) | 750 | 0.750 | 0.179 | 7.50 |
How the table was made
Values are the specific heat calculator’s own material list, from the CRC Handbook and Incropera’s property tables at about 300 K; air and steam are at constant pressure. Specific heat changes with temperature, slowly for most solids near room temperature and strongly near a phase change.
Q = m c ΔT applies only within one phase. Melting, freezing, boiling and condensing take latent heat on top: 334 kJ/kg to melt ice and 2 257 kJ/kg to boil water at 100 °C.
FAQ
What is the specific heat of water?
4 181 J/kg·K at 25 °C, about 1 Btu/lb·°F.
Why does steel heat up faster than water?
Its specific heat is about a tenth of water’s, so the same heat raises its temperature about ten times as much per kilogram.
Calculators that use this table
- Specific heat calculator (Q = mcΔT): Heat to warm or cool a material, Q = m c ΔT, or the temperature change, mass or specific heat, with the heating time at a given power.
- Latent and sensible heat calculator (air and water): Sensible, latent and total heat of an airstream by psychrometrics and the 1.08 and 4840 rules, SHR and coil load; and the heat to melt or boil water.
- Water heating time calculator (tank, element, gas or heat pump): Time to heat a water tank with an electric element, gas burner or heat pump, with standing loss, energy, cost and recovery rate in L/h or gal/h.
Sources
- CRC Handbook of Chemistry and Physics, 97th edition, Heat capacity of the elements at 25 °C, and Properties of water.
- Incropera et al., Fundamentals of Heat and Mass Transfer, 7th edition, Appendix A (300 K).