Results are estimates. They do not replace the governing code, class or flag requirements, or a check by a competent person. Report a problem
Introduction
A boat engine burns fuel in proportion to the power it delivers. Multiply the power by the specific fuel consumption, the grams of fuel per kilowatt-hour, and divide by the fuel's density to get litres per hour. A 200 hp diesel at 70 % of its rated power delivers 104 kW and burns about 28 L, or 7.4 US gallons, per hour.
This calculator gives the fuel flow from the engine power and load, or takes a measured flow, and turns it into endurance and range on the fuel in the tank after a reserve. It also gives fuel per nautical mile and the cost per hour and per mile. It is for leisure boaters planning a trip and for skippers of workboats, launches and small commercial craft.
Formulas
Power and fuel flow:
P = P_rated × load or P = P_rated × (n / n_rated)³
ṁ = P × SFC, Q = ṁ / ρ_fuel
P_rated — rated power of all engines together; n — engine rpm
SFC — specific fuel consumption: 225 g/kWh for diesel, 300 g/kWh for four-stroke petrol by default
ρ_fuel — fuel density: 0.84 kg/L for diesel, 0.745 kg/L for petrol
1 US gallon = 3.785 L
Assumptions and limitations
The default diesel SFC of 225 g/kWh sits within the 220 to 232 g/kWh of Volvo Penta's D4 engines at rated power. The petrol value of 300 g/kWh is a little above the 270 g/kWh Heywood gives as a typical best for spark-ignition engines.
Engines burn more per kilowatt-hour at light load. Below about a third of rated power the result is probably low; the engine maker's fuel curve or a flow meter is better.
The rpm option uses the propeller law, power proportional to rpm cubed. It suits displacement boats well. Planing boats depart from it, most of all around the speed where they climb onto the plane.
Range assumes calm water, a clean hull and constant speed. Head seas, wind, current and fouling all shorten it, which is what the reserve is for.
Worked example
A launch has a 200 hp diesel and cruises at 70 % power and 20 kn. It carries 400 L of fuel and keeps 20 % in reserve. Diesel costs 1.80 per litre.
Power: 200 hp × 0.70 = 140 hp = 104.4 kW.
Fuel mass: 104.4 kW × 225 g/kWh = 23.49 kg/h.
Fuel volume: 23.49 / 0.84 = 27.96 L/h, which is 7.39 US gal/h.
Usable fuel: 400 × (1 − 0.20) = 320 L, which lasts 320 / 27.96 = 11.4 h.
Range: 11.44 h × 20 kn = 229 nmi, at 1.40 L per mile.
Cost: 27.96 L/h × 1.80 = 50.33 per hour, or 2.52 per mile.
FAQ
How much fuel does a boat engine burn per hour?
At the default values a diesel burns about 0.2 L per horsepower per hour of delivered power, and a four-stroke petrol engine about 0.3 L. Multiply by the power actually used, not the rating.
How do I convert litres per hour to gallons per hour?
Divide by 3.785 for US gallons or by 4.546 for imperial gallons. 28 L/h is 7.4 US gal/h.
Why does slowing down save so much fuel?
If the power rises with the cube of speed, the fuel per mile rises with its square. Going 10 % slower then saves about 19 % per mile. Planing boats behave differently near the speed where they come onto the plane, so check with a flow meter.
What is specific fuel consumption?
The mass of fuel an engine burns for each kilowatt-hour of work. Modern small marine diesels use about 220 to 232 g/kWh at rated power, and more at light load.
How much fuel reserve should I keep?
Many skippers use the rule of thirds: a third of the fuel to go out, a third to come back and a third in reserve. Keep more when the weather or the next fuel stop is uncertain.
Should I enter the power of one engine or both?
Enter the total of all engines running. With twin 150 hp engines, the rated power is 300 hp.
Before every release the calculator must reproduce each case below. The note under each case says where the expected answer comes from: a standard, a textbook, a published table, or a hand calculation shown in full.
200 hp diesel at 70 % power: 104.4 kW × 225 g/kWh = 23.49 kg/h = 27.96 L/h = 7.39 US gal/hFuel flow = P × SFC / ρ (Heywood §2.9); SFC 225 g/kWh within the Volvo Penta D4 data (220–232 g/kWh); hand calculation
Range: 400 L with 20 % reserve at 27.96 L/h lasts 11.44 h, 228.9 nmi at 20 kn; 1.80 per litre costs 50.33 per hourEndurance = usable fuel / flow, range = endurance × speed; hand calculation
Propeller law: 80 % of rated rpm is 0.8³ = 51.2 % of rated powerMAN, Basic Principles of Ship Propulsion: P = c n³
Petrol: 150 hp at full power, 300 g/kWh and 0.745 kg/L burns 45.04 L/h (11.90 US gal/h); a 40 nmi trip at 35 kn uses 51.5 LFuel flow = P × SFC / ρ; hand calculation
Measured flow of 25 L/h at 8 kn: 3.125 L/nmi; with a 200 L tank and no reserve, 8 h and 64 nmiHand calculation
Light load warns; zero speed gives no range; zero power and an SFC out of range are rejectedBehaviour check: warnings and rejected inputs
Worked example of the article: the calculator reproduces 104.4 kW, 27.96, 7.39, 11.4 h, 229 nmi, 50.33 to the digits printedThe worked example on this page, to the digits printed
Assumptions and sources
Assumptions and limits
Fuel flow is power × specific fuel consumption ÷ fuel density. The default SFC is 225 g/kWh for diesel (Volvo Penta D4 series, 220–232 g/kWh at rated power) and 300 g/kWh for four-stroke petrol engines, a little above the 270 g/kWh Heywood gives as a typical best value.
SFC rises at light load: below about a third of rated power a diesel can burn 10 to 30 % more per kWh than at its best point. Use the engine maker's fuel curve or a measured flow where you have one.
With the load given as a share of rated rpm, the power follows the propeller law P ∝ n³ (MAN, Basic Principles of Ship Propulsion). Planing boats depart from it, especially around the hump speed.
Range and endurance use the usable fuel after the reserve, at constant speed and load, in calm water with a clean hull. Wind, sea, current and fouling all cut the range.
Prices are per litre in any single currency; for a price per US gallon divide by 3.785.
Sources
J.B. Heywood, Internal Combustion Engine Fundamentals (McGraw-Hill, 1988), §2.9: specific fuel consumption (typical best values about 270 g/kWh for spark-ignition and 200 g/kWh for diesel engines)
Volvo Penta D4 series marine diesel data (D4-180 to D4-300): specific fuel consumption 220–232 g/kWh at rated power
MAN Energy Solutions, Basic Principles of Ship Propulsion (2018): the propeller law, power proportional to the cube of the speed
EN 590:2022 (diesel) and EN 228:2012+A1:2017 (petrol): density limits at 15 °C
Cite this calculator
Papandreou, C. (2026). Boat fuel consumption calculator. Engineering Bible. https://engineeringbible.com/maritime/boat-fuel/
Embed this calculator on your site
Copy this HTML into your page. The calculator stays free to use and links back here.