Skip to content
Engineering Bible

Results appear as you type. Use the arrow keys to move through them and Enter to open one.

Popular

↑ ↓ moveEnter openEsc close

Planing boat speed calculator (Crouch formula)

Top speed of a planing boat from shaft horsepower and weight by Crouch's formula, with C by hull type, and the power needed for a target speed.

Units

Results are estimates. They do not replace the governing code, class or flag requirements, or a check by a competent person. Report a problem

Introduction

A planing boat's speed depends mainly on how many pounds of boat each horsepower has to push. Crouch's formula puts this in one line: speed in knots equals a constant C divided by the square root of the weight in pounds per shaft horsepower. A 5 000 lb runabout with 200 shp carries 25 lb per horsepower, so with C = 150 it makes 150 / √25 = 30 kn.

This calculator gives the speed of a planing boat from its loaded weight, shaft power and hull type, using the constants Dave Gerr tabulates in The Propeller Handbook. It also works the other way, giving the power for a target speed. It is for boat owners repowering or choosing an engine, and for anyone checking a dealer's speed claim.

Formulas

Crouch's planing formula and its inverse:

V = C / √(W / P)          V in kn, W in lb, P in shp
P = W × (V / C)²

The same in metric units:

V = 0.780 × C × √(P[kW] / W[kg])

Crouch constants C (Gerr):

  • 150 — average runabouts, cruisers and passenger vessels
  • 190 — high-speed runabouts and very light high-speed cruisers
  • 210 — race boats
  • 220 — three-point and stepped hydroplanes
  • 230 — racing power catamarans and sea sleds

Assumptions and limitations

  • The formula applies to boats that are truly planing, above a speed–length ratio of about 3. Below that it overestimates the speed of displacement and semi-displacement hulls.
  • W is the weight as the boat runs: hull, engines, fuel, water, crew and gear. Use a realistic load, not the brochure's dry weight.
  • P is shaft horsepower at the propeller. Gearboxes and stern drives lose a few percent of the engine's rated power.
  • C sums up hull form, propeller and trim. The table gives typical values. If you know the speed of a sister boat, work out its C and use that instead.

Worked example

A runabout weighs 5 000 lb loaded and has 200 shaft horsepower. It is an average planing hull, C = 150. How fast will it go, and what power would give 35 kn?

  1. Weight per horsepower: 5 000 / 200 = 25.0 lb/hp.
  2. Speed: 150 / √25.0 = 150 / 5 = 30.0 kn, or about 34.5 mph.
  3. Power for 35 kn: 5 000 × (35 / 150)² = 5 000 × 0.0544 = 272 shp.

So 36 % more power buys about 17 % more speed, because speed grows with the square root of power.

FAQ

How fast will my boat go with a given engine?

Divide the loaded weight in pounds by the shaft horsepower, take the square root, and divide C by it. With C = 150 and 25 lb/hp the answer is 30 kn.

How much horsepower do I need for 30 knots?

Multiply the weight by (30 / C)². A 5 000 lb boat with C = 150 needs 5 000 × 0.04 = 200 shp.

Which constant C should I use?

Start with Gerr's value for your hull type. Better still, work out C from a similar boat whose speed and power you know: C = V × √(W / P).

How much does extra weight slow a planing boat?

Speed falls with the square root of weight. Adding 10 % to the weight cuts the speed by about 4.7 %, all else equal.

Does the formula work in kilograms and kilowatts?

Yes, with a conversion factor: V = 0.780 × C × √(kW / kg). The calculator converts units for you.

Why does my boat not reach the predicted speed?

Common causes are more weight than assumed, a fouled bottom, the wrong propeller pitch, or an engine that does not reach its rated rpm. Check the propeller with the pitch calculator.

Related calculators

What this calculator is checked against

Before every release the calculator must reproduce each case below. The note under each case says where the expected answer comes from: a standard, a textbook, a published table, or a hand calculation shown in full.

  1. 5 000 lb runabout with 200 shp, C = 150: 25 lb/hp and 150 / √25 = 30.0 knCrouch's formula and constants as given in Gerr, The Propeller Handbook, ch. 2; hand calculation
  2. Inverse: 35 kn for the same boat needs 5 000 × (35/150)² = 272.2 shpP = W (V/C)²; hand calculation
  3. Gerr's constants: 190 high-speed runabouts, 210 race boats, 220 hydroplanes, 230 racing catamaransGerr, The Propeller Handbook, table of Crouch constants
  4. Speed scales with √(P/W): four times the power doubles the speedCrouch's formula; consistency check
  5. A 20 ft waterline at 12 kn is S/L 2.68 and warns that the boat is not planing; zero weight is rejectedBehaviour check: warnings and rejected inputs
  6. Worked example of the article: the calculator reproduces 25.0, 30.0 kn to the digits printedThe worked example on this page, to the digits printed

Assumptions and sources

Assumptions and limits

  • Crouch's formula V = C / √(W / P) is an empirical fit for planing hulls (speed in knots, weight in pounds, shaft horsepower). It does not apply to displacement or most semi-displacement hulls below a speed–length ratio of about 3.
  • W is the loaded weight of the boat as it runs: hull, engines, fuel, water, people and gear. A half-loaded boat is noticeably faster than a fully loaded one.
  • P is shaft horsepower delivered to the propeller. Gearboxes and stern drives lose a few percent of the engine's rated power, and the rating itself is at the top of the rpm range.
  • The constant C depends on the hull and its propeller: Gerr tabulates 150 for average runabouts and cruisers up to 230 for racing catamarans. The best value comes from a sister boat with a known speed and power.

Sources

  • D. Gerr, The Propeller Handbook (International Marine, 1989), ch. 2: Crouch's planing speed formula and the table of Crouch constants C
  • D. Savitsky, Hydrodynamic design of planing hulls, Marine Technology 1(1), 1964, pp. 71–95 (the physics-based method for planing resistance behind empirical rules such as Crouch's)

Cite this calculator

Papandreou, C. (2026). Planing boat speed calculator (Crouch formula). Engineering Bible. https://engineeringbible.com/maritime/planing-speed/

Embed this calculator on your site

Copy this HTML into your page. The calculator stays free to use and links back here.

By Christos Papandreou. Updated . How the numbers are checked.