Skip to content
Engineering Bible

Results appear as you type. Use the arrow keys to move through them and Enter to open one.

Popular

↑ ↓ moveEnter openEsc close

Thrust-to-weight, wing loading and stall speed calculator

Thrust-to-weight ratio, wing loading, power loading and stall speed for aircraft, drones and rockets, with the vertical acceleration at full thrust.

Units

Results are estimates. They do not replace the governing code, class or flag requirements, or a check by a competent person. Report a problem

Introduction

The thrust-to-weight ratio compares the push of the engines with the weight they must move. Above 1, a rocket or drone can climb straight up. Wing loading is the weight carried by each square foot of wing, and it sets the stall speed. A four-seat trainer of 2 550 lb with 174 ft² of wing carries 14.66 lb/ft² and stalls at about 54 kn with a maximum lift coefficient of 1.5.

This calculator gives the thrust-to-weight ratio and the net vertical acceleration, the wing loading, the power loading and the stall speed at an altitude. Each part is optional, so it serves aircraft, drones and rockets. It is for pilots, students, drone builders and model-rocket fliers.

Formulas

Ratios and loadings:

W = m × g
T/W = thrust / W
a_vertical = g × (T/W − 1)
wing loading = W / S
power loading = W / P

Stall speed:

V_s = √(2 W / (ρ S CL_max))
  • m — mass; g = 9.81 m/s²; S — wing area; P — engine power
  • ρ — air density from the standard atmosphere at the altitude
  • CL_max — maximum lift coefficient of the wing, from the aircraft data
  • In US units 1 lb of mass weighs 1 lbf, so wing loading in lb/ft² is the same number in lbf/ft²

Assumptions and limitations

  • Thrust is the static thrust. Propeller thrust falls as the aircraft speeds up, and jet thrust changes with speed and altitude.
  • The vertical acceleration ignores drag and the mass burned off. It is the value at lift-off or the start of a climb.
  • The stall speed is for level flight at the weight entered. In a banked turn the load factor raises it by the square root of the load factor.
  • CL_max depends on the wing, the flaps and the Reynolds number. Use the value from the aircraft or wing-section data.
  • The stall speed shown is a true airspeed. The indicated stall speed stays about the same at every altitude.

Worked example

A four-seat trainer weighs 2 550 lb at gross weight, has 174 ft² of wing and a 180 hp engine. Its wing reaches a CL_max of 1.5 without flaps. What are its loadings and its stall speed at sea level?

  1. Wing loading: 2 550 / 174 = 14.66 psf, or 1 156.7 kg / 16.17 m² = 71.6 kg/m².
  2. Power loading: 2 550 / 180 = 14.17 lb per hp.
  3. Wing loading in SI: 11 343 N / 16.17 m² = 701.7 Pa.
  4. Stall speed: √(2 × 701.7 / (1.225 × 1.5)) = 27.64 m/s = 53.7 kn.

At a density altitude of 5 000 ft the same aircraft stalls at 57.9 kn true airspeed, at about the same indicated airspeed.

FAQ

What is a good thrust-to-weight ratio?

Above 1 for anything that must climb vertically, such as a rocket or a multirotor drone. Airliners and light aircraft fly with ratios well below 1 because the wing carries the weight.

How do I calculate wing loading?

Divide the weight by the wing area. A 2 550 lb aircraft with 174 ft² of wing carries 14.66 lb/ft².

How do I calculate stall speed?

Take the square root of 2 × weight / (air density × wing area × CL_max). Use consistent units, such as N, kg/m³ and m².

Why does stall speed increase with altitude?

The air is thinner, so the wing must move faster through it to make the same lift. The indicated stall speed stays about the same.

What is power loading?

The weight per unit of engine power, in lb/hp or kg/kW. A lower number means better climb and take-off performance.

How does weight change the stall speed?

It grows with the square root of the weight. Ten percent more weight raises the stall speed by about 4.9 %.

Related calculators

What this calculator is checked against

Before every release the calculator must reproduce each case below. The note under each case says where the expected answer comes from: a standard, a textbook, a published table, or a hand calculation shown in full.

  1. 2 550 lb, 174 ft², 180 hp: wing loading 14.66 lb/ft² (71.6 kg/m²), power loading 14.17 lb/hp; CL_max 1.5 stalls at 53.7 knHand calculation, V_s = √(2W/(ρ S CL_max)) (Anderson, Aircraft Performance and Design, Ch. 5)
  2. ISA density: 1.2250 kg/m³ at sea level, 0.9046 kg/m³ at 10 000 ft (σ = 0.7385)ICAO Doc 7488/3 table
  3. At altitude the true stall speed rises as 1/√σ: 5 000 ft gives 53.72 / √0.8617 = 57.9 knV_s ∝ 1/√ρ; equivalent stall speed unchanged
  4. Rocket of 1 000 kg with 14 710 N of thrust: T/W 1.5, net acceleration 0.5 g straight upa = g0 (T/W − 1)
  5. A 1.5 kg drone with 2.2 kgf of thrust can climb; a jet trainer at T/W 0.4 needs its wingT/W > 1 condition for vertical flight
  6. Zero mass, negative thrust and a CL_max of 0.1 are rejectedBehaviour check: warnings and rejected inputs
  7. Worked example of the article: the calculator reproduces 14.66 psf, 71.6, 14.17, 53.7 kn to the digits printedThe worked example on this page, to the digits printed

Assumptions and sources

Assumptions and limits

  • Weight is mass × standard gravity 9.806 65 m/s²; 1 lb of mass weighs 1 lbf, so lb/ft² and lbf/ft² are the same number for wing loading.
  • The thrust-to-weight ratio uses the static thrust given (sea-level static for jets and rockets, measured for a drone); above 1 the vehicle can accelerate straight up, and the net vertical acceleration is g (T/W − 1) before drag.
  • The stall speed is the speed at which lift at CL_max equals the weight in level, unaccelerated flight: V_s = √(2 W / (ρ S CL_max)). It is a true airspeed; the equivalent (and roughly indicated) stall speed is the same at every altitude.
  • CL_max comes from the aircraft or wing-section data and rises with flaps; a load factor n, as in a banked turn, raises the stall speed by √n.
  • Air density is the ICAO standard atmosphere value at the altitude entered; use the density altitude for a hot or high day.

Sources

  • J.D. Anderson, Aircraft Performance and Design, McGraw-Hill 1999, Chapter 5 (stall speed V_stall = √(2W / (ρ S C_L,max)), thrust-to-weight ratio and wing loading)
  • D.P. Raymer, Aircraft Design: A Conceptual Approach, 6th ed., AIAA 2018, Chapter 5 Thrust-to-weight ratio and wing loading
  • ICAO Doc 7488/3, Manual of the ICAO Standard Atmosphere, 3rd ed. 1993 (density with altitude)

Cite this calculator

Papandreou, C. (2026). Thrust-to-weight, wing loading and stall speed calculator. Engineering Bible. https://engineeringbible.com/automotive/thrust-to-weight/

Embed this calculator on your site

Copy this HTML into your page. The calculator stays free to use and links back here.

By Christos Papandreou. Updated . How the numbers are checked.