Results are estimates. They do not replace the governing code, class or flag requirements, or a check by a competent person. Report a problem
Introduction
True airspeed is the speed of an aircraft through the air around it. The airspeed indicator measures the pressure of the oncoming air, and it is calibrated for sea-level standard air. Higher up the air is thinner, so the indicator reads low and the true airspeed is higher. At 8 000 ft and 0 °C, a calibrated airspeed of 150 kn is a true airspeed of 169 kn.
This calculator converts indicated or calibrated airspeed to true airspeed and Mach number with the compressible-flow relations of the standard atmosphere. It also gives the equivalent airspeed and the ground speed with a head or tail wind. The 2 % per 1 000 ft rule of thumb is shown for comparison. It is for pilots planning a flight, student pilots learning the E6B, and drone and model-aircraft builders.
Formulas
Impact pressure from calibrated airspeed, and Mach number:
a = √(γ R T)
TAS = M × a
EAS = a0 × M × √(p / p0)
GS = TAS − head wind
Rule of thumb for comparison:
TAS ≈ CAS × (1 + 0.02 × PA / 1 000 ft)
V_c — calibrated airspeed, IAS plus the POH correction
p — static pressure at the pressure altitude PA; T — outside air temperature in K
p0 = 29.92 inHg; a0 = 661.48 kn, the sea-level speed of sound
γ = 1.4; R = 287.05 J/(kg·K)
Assumptions and limitations
The relations hold for subsonic flight. The calculator stops at Mach 1.
Indicated airspeed needs the position and instrument correction from the airspeed calibration table. Without it, IAS is taken as CAS.
The temperature is the static outside air temperature. At jet speeds a probe reads warmer air, and that ram rise must be removed first.
The ground speed uses only the wind component along the track. A crosswind also needs a wind correction angle.
The 2 % rule ignores temperature. It reads high on cold days and low on hot ones.
Worked example
A pilot flies at 150 kn calibrated airspeed at a pressure altitude of 8 000 ft. The outside air temperature is 0 °C, and the forecast head-wind component is 20 kn. What are the true airspeed and the ground speed?
Static pressure at 8 000 ft in the standard atmosphere: 752.6 hPa.
The rule of thumb gives 150 × 1.16 = 174.0 kn, about 5 kn high because the day is colder than it assumes.
FAQ
What is true airspeed?
The speed of the aircraft relative to the air mass. It is the speed used for navigation, before the wind is applied.
How do I calculate true airspeed?
Convert the calibrated airspeed to a Mach number with the static pressure at the pressure altitude. Multiply by the speed of sound at the outside temperature.
What is the rule of thumb for TAS?
Add 2 % of the calibrated airspeed for every 1 000 ft of altitude. It is close at low altitude on a standard day.
What is the difference between IAS, CAS, EAS and TAS?
IAS is what the instrument shows. CAS corrects it for installation errors, EAS corrects CAS for compressibility, and TAS corrects EAS for air density.
Why is true airspeed higher than indicated at altitude?
The air is thinner, so the same dynamic pressure needs a higher speed. Indicated airspeed tracks dynamic pressure.
How do I get ground speed from true airspeed?
Subtract the head-wind component, or add the tail-wind component. A large crosswind also reduces the ground speed slightly.
Related calculators
Density altitude — pressure and density altitude from the airport conditions.
Before every release the calculator must reproduce each case below. The note under each case says where the expected answer comes from: a standard, a textbook, a published table, or a hand calculation shown in full.
Sea-level standard day: TAS = EAS = CAS (150 kn), speed of sound 661.48 kn (340.294 m/s)Definition of calibrated airspeed; ICAO Doc 7488/3 a0 = 340.294 m/s
ISA tables: 11 000 m is 22 632 Pa and 216.65 K (speed of sound 573.6 kn); 8 000 ft is 752.6 hPaICAO Doc 7488/3 standard atmosphere tables
CAS 150 kn at 8 000 ft and 0 °C: Mach 0.2625, TAS 169.1 kn, EAS 149.7 kn, ground speed 149.1 kn into 20 knHand calculation with q_c = p0[(1 + 0.2(Vc/a0)²)^3.5 − 1], M = √(5[(q_c/p + 1)^(2/7) − 1]) (Anderson, Ch. 3)
Airliner: 280 kn CAS at FL350 on a standard day is Mach 0.821, TAS 473 kn; EAS is below CASSame relations at ISA 35 000 ft (−54.34 °C); compressibility makes EAS < CAS
IAS with a +2 kn correction equals CAS 2 kn higher; a 25 kn tail wind adds to the ground speedCAS = IAS + correction (POH calibration table); GS = TAS − head wind
A supersonic CAS and a pressure altitude above 20 km are rejected; a head wind above TAS gives no ground speedBehaviour check: warnings and rejected inputs
Worked example of the article: the calculator reproduces 0.2625, 169.1 kn, 149.7 kn, 149.1 kn, 174.0 kn to the digits printedThe worked example on this page, to the digits printed
Assumptions and sources
Assumptions and limits
Calibrated airspeed is converted with the compressible (isentropic) pitot-static relations for subsonic flow, the same relations the airspeed indicator is calibrated to at sea-level standard conditions (a0 = 661.48 kn, p0 = 29.92 inHg).
Indicated airspeed becomes calibrated airspeed by adding the position and instrument correction from the airspeed calibration table of the POH or AFM; with no correction entered, IAS is taken as CAS.
The outside air temperature is the static air temperature; at jet speeds a probe reads a higher total temperature, which must be corrected first (the Mach number output gives T_total = T (1 + 0.2 M²) for that check).
The static pressure comes from the pressure altitude through the ICAO standard atmosphere, valid to 65 617 ft (20 km).
Ground speed is the true airspeed minus the head-wind component along the track (a tail wind is negative); the wind correction angle of a crosswind is not included.
Sources
ICAO Doc 7488/3, Manual of the ICAO Standard Atmosphere, 3rd ed. 1993 (p0 = 101 325 Pa, T0 = 288.15 K, a0 = 340.294 m/s, γ = 1.4, R = 287.05287 J/(kg·K))
FAA-H-8083-25C, Pilot’s Handbook of Aeronautical Knowledge (2023), Chapter 8 Flight Instruments: indicated, calibrated, equivalent and true airspeed
J.D. Anderson, Introduction to Flight, 8th ed., McGraw-Hill 2016, Chapter 3 (measurement of airspeed: compressible subsonic flow, calibrated airspeed)
Cite this calculator
Papandreou, C. (2026). True airspeed calculator (TAS and Mach). Engineering Bible. https://engineeringbible.com/automotive/true-airspeed/
Embed this calculator on your site
Copy this HTML into your page. The calculator stays free to use and links back here.